This is a working overview of epithalamin, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-01-20 and is reviewed periodically as new material appears.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
| Property | Value | Notes |
|---|---|---|
| Amino acid sequence | Ala-Glu-Asp-Gly | Linear tetrapeptide, also written AEDG |
| Molecular mass | About 390.35 g/mol | Value calculated from the sequence |
| Appearance | White to off-white powder | Lyophilised material forms a loose cake |
| Solubility | Freely soluble in water | Also dissolves in isotonic saline |
| Storage | -20 °C, desiccated | Aliquot solutions to avoid freeze–thaw cycling |
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.
Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.
Gas phase ion chemistry is a field of science encompassed within both chemistry and physics. It is the science that studies ions and molecules in the gas phase, most often enabled by some form of mass spectrometry. By far the most important applications for this science is in studying the thermodynamics and kinetics of reactions. For example, one application is in studying the thermodynamics of the solvation of ions. Ions with small solvation spheres of 1, 2, 3... solvent molecules can be studied in the gas phase and then extrapolated to bulk solution. Transition state theory is the theory of the rates of elementary reactions which assumes a special type of chemical equilibrium (quasi-equilibrium) between reactants and activated complexes. RRKM theory is used to compute simple estimates of the unimolecular ion decomposition reaction rates from a few characteristics of the potential energy surface.
Alfred Stracher (1931-2013) was an American biochemist and the founder and editor-in-chief of Drug Delivery. During his lifetime, he was Distinguished Professor of Biochemistry at SUNY Downstate Medical Center. Alfred Stracher was born in Albany, New York in 1931. He graduated from Rensselaer Polytechnic Institute in 1952 with a Bachelor of Science in Chemistry. He received his PhD in Chemistry from Columbia University in 1956.
The idea of Food Social Security stemmed from noticing various flaws inherent to the current food system such as malnutrition, food insecurity, farmers' precarity and environmental concerns. Globally, while enough food is produced to feed ten billion people, food systems are threatening both human health and environmental sustainability. Food bank demand is soaring throughout the world, and is in itself not seen as a long-term response to food insecurity. Poor nutrition is generally linked to lower incomes, causing one of the largest public health challenges for children, and a significant strain on healthcare systems. The three fundamental principles of Food Social Security are:
This technology entails the joining of DNA from different species and the subsequent insertion of the hybrid DNA into a host cell. One of the first individuals to develop recombinant DNA technology was a biochemist at Stanford by the name of Paul Berg. In his experimental design in 1974, he cleaved (cut into fragments) the monkey virus SV40. He then cleaved the double helix of another virus, an antibacterial agent known as bacteriophage lambda. In the third step, he fastened DNA from the SV40 to DNA from the bacteriophage lambda. The final step involved placing the mutant genetic material into a laboratory strain of the E. coli bacterium. This last step, however, was not completed in the original experiment.
Righthanded β-helices, typified by the pectate lyase enzyme shown at left or P22 phage tailspike protein, have a less regular cross-section, longer and indented on one of the sides; of the three linker loops, one is consistently just two residues long and the others are variable, often elaborated to form a binding or active site. A two-sided β-helix (right-handed) is found in some bacterial metalloproteases; its two loops are each six residues long and bind stabilizing calcium ions to maintain the integrity of the structure, using the backbone and the Asp side chain oxygens of a GGXGXD sequence motif. This fold is called a β-roll in the SCOP classification.
Sources: en.wikipedia.org
BIA Separations was formed in 1998 by a group of scientists in Ljubljana, Slovenia to commercialize a new chromatographic resin based on monolith technology. Monolithic resin was developed independently by three different laboratories in late 1980s led by Hjertén, Švec and Tennikova. The company was one of the few Slovenian companies to receive venture capital funding at that time-Horizonte Venture Management realizing the potential of monoliths made the initial investment in the company. During that year, BIA Separations released its first commercial product marketed under the trade name of CIM (Convective Interaction Media). The new technique was named HPMC (High Performance Monolith Chromatography). During the 1999 and 2000s, the company promoted this new platform technology to the scientific and business community and registered several patents. In 2007 the company headquarters moved to Villach, Austria. In 2011 BIA Separations entered a strategic partnership with Japan Synthetic Rubber Corporation, a Japanese company producing synthetic materials. A strategic partnership agreement with Showa Denko K.K. (SDK) was signed in 2012.
In plants, ATP synthase is also present in chloroplasts (CF1FO-ATP synthase). The enzyme is integrated into thylakoid membrane; the CF1-part sticks into stroma, where dark reactions of photosynthesis (also called the light-independent reactions or the Calvin cycle) and ATP synthesis take place. The overall structure and the catalytic mechanism of the chloroplast ATP synthase are almost the same as those of the bacterial enzyme. However, in chloroplasts, the proton motive force is generated not by respiratory electron transport chain but by primary photosynthetic proteins. The synthase has a 40-aa insert in the gamma-subunit to inhibit wasteful activity when dark. CF1FO-ATP synthase is less efficient to its mitochondrial counterpart and exchanges 4—4.67 protons per ATP.
With ring-opening polymerization, automated synthesis has been used for rapid screening and optimization, including with catalyst + initiator systems and their polymerization conditions. For example, Hoogenboom et al. determined the optimal temperature for the polymerization of 2-ethyl-2-oxazoline in dimethylacetamide (DMAc), allowing for individual heating of the parallel reactors, which shortened the time needed for preparation and analysis. To aid with the catalyst research for polyolefins, Symyx Technologies Inc. used automated synthesis to create a library of palladium and nickel catalysts, which were screened for ethylene polymerization. This process found that the largest polyethylene polymers were created by the complexes with the highest steric hindrance for the ortho-positions of the aryl rings, while electronic factors did not influence yield or molecular weight. In addition, Tuchbreiter and Mülhaupt used automated synthesis to demonstrate the improvements of minireactors for the polymerization of olefins, with quality improving as compared to utilizing simple arrays.
Automated synthesis or automatic synthesis is a set of techniques that use robotic equipment to perform chemical synthesis using a robotic system run using software control. Automating processes allows for higher efficiency and product quality although automation technology can be cost-prohibitive and there are concerns regarding overdependence and job displacement. Chemical processes were automated throughout the 19th and 20th centuries, with major developments happening in the previous thirty years, as technology advanced. Tasks that are performed may include: synthesis in variety of different conditions, sample preparation, purification, and extractions. Applications of automated synthesis are found on research and industrial scales in a wide variety of fields including polymers, personal care, and radiosynthesis.
Sources: en.wikipedia.org
When the apical bud is removed, the lowered IAA concentration allows the lateral buds to grow and produce new shoots, which compete to become the lead growth. Pruning techniques such as coppicing and pollarding make use of this natural response to curtail direct plant growth and produce a desired shape, size, and/or productivity level for the plant. The principle of apical dominance is manipulated for espalier creation, hedge building, or artistic sculptures called topiary. If the SAM is removed, it stimulates growth in the lateral direction. By careful pruning, it is possible to create remarkable designs or patterns. Some fruit trees have strong apical dominance, and young trees can become "leggy", with poor side limb development. Apical dominance can be reduced in this case, or in cases where limbs are broken off by accident, by cutting off the auxin flow above side buds that one wishes to stimulate. This is often done by orchardists for young trees. Occasionally, strong apical dominance is advantageous, as in the "Ballerina" apple trees. These trees are intended to be grown in small gardens, and their strong apical dominance combined with a dwarfing rootstock gives a compact narrow tree with very short fruiting side branches.
Normal phase elution is achieved by pumping the non-aqueous or phase of a biphasic solvent system through the column as the mobile phase, with a more polar stationary phase being retained in the column. The cause of original nomenclature of is relevant. As original stationary phases of paper chromatography were superseded by more efficient materials such as diatomaceous earths (natural micro-porous silica) and followed by modern silica gel, the thin-layer chromatography stationary phase was polar (hydroxy groups attached to silica) and maximum retention was achieved with non-polar solvents such as n-hexane. Progressively more polar eluents were then used to move polar compounds up the plate. Various alkane bonded phases were tried with C18 becoming the most popular. Alkane chains were chemically bonded to the silica, and a reversal of the elution trend occurred. Thus a polar stationary became "normal" phase chromatography, and the non-polar stationary phase chromatography became "reversed" phase chromatography.
Agarose gel electrophoresis is a technique widely used to estimate the size of nucleic acid fragments and identify them based on their differential mobility in the gel. Nucleic acids are commonly stained and detected using either ethidium bromide or SYBR Green dyes. The most common electrophoretic stain in agarose gel is ethidium bromide, however, SYBR green presents greater resolution and yield for single-stranded nucleic acid detection. The dyes grant fluorescence to DNA and RNA under 300 nm UV light. This occurs due to their intercalating nature. In double helical nucleic acids, the dyes bind between two strands, and in single-stranded nucleic acids, the dyes bind short, duplex segments formed within a strand.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.
AEDG is the one-letter code for the four amino acids alanine, glutamate, aspartate and glycine in that order. The same molecule is written in three-letter form as Ala-Glu-Asp-Gly.
Identity is normally confirmed by mass spectrometry against the calculated mass of roughly 390.35 g/mol. Purity is then estimated by reversed-phase high-performance liquid chromatography with ultraviolet detection.
The molecule lacks aromatic residues, so it absorbs weakly near 280 nanometres, the wavelength applied to many other peptides. The peptide bond absorbs strongly below 220 nanometres, making 214 nanometres a practical compromise. Gradient methods must therefore use mobile phases with low ultraviolet absorbance to keep the baseline clean.